Deep Sky Dad FP1
Features
Making flats can be quite cumbersome, especially if you stride towards automation and simplification of the process. Our flap panel makes making flat frames with your refractor telescopes part of automated routine, without hacks like LCD screens, sky with T-shirt etc.
While you image, flap panel is neatly tucked away next to the refractor tube. When you finish imaging, you simply close it up and turn on (dimmable) LED light. You can adjust the brightness according to your camera responsiveness/gain settings and different filters.
But that is not all! For those with high humidity conditions, we are also offering an optional accessory – built in heater, which keeps dew at bay. So you do not need an extra heating strip.
Main Control Tab
- Dust cover: open/close the flap panel
- Flat Light: turn LED panel on/off
- Absolute Position: Set the number of absolute steps.
- Brightness: brightness of led panel in range 1-4096
- Heater mode (if heater installd): 3 modes: Off, On, On if panel is open or LED is active
Presets
You may set pre-defined presets for common LED brightness values positions in the Presets tab (depends on camera/telescope):
Connection
Connect to the focuser using a micro USB cable. The connection type is serial and by default the port is set to /dev/ttyACM0. The default baud rate is 115200. If you change the default port, save the changes by going to the Options tab and click Save configuration.
Operation
After establishing connection to the flap panel, you can use the flap panel control in the INDI control panel directly to open/close the panel and turn LED on/off Alternatively, the flap panel can be used in any INDI compatible application.
Driver Name
DeepSkyDad FP1
Driver Executable
indi_deepskydad_fp1
Family
Auxiliary (Light Box, Dust Cap)
Manufacturer
DeepSkyDad
Platforms
Linux, BSD, MacOS
Author
Pavle Gartner
Version
1.0
