Directory: All Listings 

The Omegon EQ500-X Equatorial Mount driver is included with libindi >= 1.7.8. :   Features The Omegon EQ500-X Equatorial Mount driver supports: 4 Slew Rates (max, find, center and guide) Single sidereal tracking rate Goto coordinates (via ...
Read More...

The Telescope-Control-System TCS of ALLUNA Optics has been designed for the remote control of high-quality telescopes. Alluna Optics provides only ASCOM drivers and a Windows EXE program to control the TCS2 Device. The TCS2 can also be controlled by an op ...
Read More...

Installation DragonLIGHT is included with libindi. Features The DragonLIGHT is a DC powered flat panel controller to illuminate any 12V light source. Configuration As a network device, you will need to connect the DragonLIGHT to your network. Just co ...
Read More...

DragonLAIR is included with libindi: Features The DragonLAIR is a DC powered roll off roof controller, capable of moving full buildings 6,500lbs (3,000kg) and more. It has a built in web server, redundant networking, 4 safety sensors, and 2 limit switch ...
Read More...

 Features The relay controller is an industrial 8-ch relay module controlled via Ethernet port, adopts Modbus RTU/Modbus TCP protocols, supports PoE power supply, also comes with an ABS rail-mount case. Features flash-on, flash-off function, by p ...
Read More...

Features With the release of INDI v2.0.9, a new INDI Universal Roll-Off Roof (ROR) driver was introduced. Up to this point, there was no standanrd implementation for a simple ROR in INDI. Depending on you control your roof, you had to write your own INDI ...
Read More...

 Features The INDI GPIO driver uses the libgpiod library to access the system's GPIO interface. It only supports ports labeled as GPIO by the kernel. Both inputs and outputs are On/Off switches. The status of output switches cannot be determined, so ...
Read More...

Pre-requisite: Please ensure that the I2C interface is enabled on your AStarBoxbefore starting the AStarBox Indi driver – see the AStarBox software installationguide for more information. The driver will not run if the box is solely powered via theUSB-C s ...
Read More...

Features The DarkLight Cover/Calibrator (DLC) is a versatile DIY solution using an Arduino Nano or compatible microcontroller. The latest iteration of the DLC features a modular design that offers options to exclusively drive a 12V light panel ...
Read More...

Features Driver for AAG Solo Cloudwatcher from [Lunatico Astronomia[(https://lunaticoastro.com/) The Solo is a small rasberry pi based computer which can be directly attached to the CloudWatch weather monitoring sensor. The solo is intented to be alway ...
Read More...